Full Color Transfer Instructions

STEP 1:

SET TEMPERATURE, PRESSURE & TIME

TEMPERATURE: 300-340F

TIME: 15 SECONDS

PRESSURE: HIGH

  • Manual Press: Tighten dial until the press won’t close. Loosen dial progressively until the press closes.
  • Hotronix and Geo Knight: 8-9
  • Pneumatic Press: 40-50 PSI

STEP 2:

PRE PRESS THE TEE FOR 10 SECONDS

Pressing the tee removes the moisture from the tee ensuring proper adhesion and minimizing potential for shrinakge. 

STEP 3:

PRESS TRANSFER GRAPHIC ON TEE FOR 15 SECONDS

STEP 4:

LET TRANSFER COOL FOR AT LEAST 20-30 SECONDS BEFORE PEELING TRANSFER SHEET

If the transfer isn't sticking, try removing T-Shirt from the heat press platen or allowing more time to cool. 

STEP 5: Optional

PLACE TEFLON SHEET OVER TEE AND PRESS AGAIN FOR 10-15 SECONDS ( PEEL TEFLON SHEET HOT )

  • Always test press your transfer on a spoiled or old tee to dial in your heat press before pressing your production
  • Transfer not sticking to the tee? Increase your pressure, ensure even heating, and quickly peel your transfer within 2 seconds. 
  • Still won't peel easily? Repress for 4 seconds then try using a different corner
  • These insturctions are just your starting point, each garment and material is different and should be tested to ensure proper adhesion. 
  • Do not repress puff transfers after peeling from transfer sheet. 

Washing Instructions: Wash inside out, cool water and cool dryer settings. 

Select Currency

{CC} - {CN}
Cancel